Geekcreit® RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

From B-Wiki
Revision as of 19:50, 30 December 2020 by Tinel (talk | contribs) (Created page with "{{Header|Geekcreit® RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable}} = Features = It using 22AWG wire, copper wire inside is very thick, can be resis...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
Geekcreit® RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

https://bogza.ro/index.php/Geekcreit%C2%AE_RAMPS_1.4_Endstop_Switch_For_RepRap_Mendel_3D_Printer_With_70cm_Cable
Geekcreit® RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable
Geekcreit® RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable
Geekcreit® RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

Features

It using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug

  • Board Size: Approx. 39 x 16 x 7mm / 1.54 x 0.63 x 0.28 inch
  • Cable Length: Approx. 70 cm / 27.56 inch

Connection Description

  • Red line connecting VCC (ramps of +)
  • Connect the black wire GND (ramps of -)
  • Green Line connection SIGNAL (ramps in s)

Tips: Under normal circumstances, the system must be configured to at least three mechanical switches.

Package Included

10 x 3D Printer Endstop Switch

RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable