Octoprint: Difference between revisions
Jump to navigation
Jump to search
m (→How to connect) |
m (→How to connect) |
||
Line 8: | Line 8: | ||
* Open ssh session | * Open ssh session | ||
* | * Create a virtual desktop using vncserver | ||
<syntaxhighlight lang="Bash"> | <syntaxhighlight lang="Bash"> | ||
Line 14: | Line 14: | ||
</syntaxhighlight> | </syntaxhighlight> | ||
* Connect to the virtual desktop | |||
<syntaxhighlight lang="Bash"> | |||
Address 192.168.2.188:1 <- :1 is the desktop number | |||
</syntaxhighlight>\ | |||
* Kill the desktop when not needed | |||
<syntaxhighlight lang="Bash"> | |||
pi@raspberrypi:~ $ vncserver -kill :1 | |||
</syntaxhighlight> | |||
== Hardware == | == Hardware == |
Revision as of 15:48, 1 May 2020
OctoPrint setup
Base guide: https://community.octoprint.org/t/setting-up-octoprint-on-a-raspberry-pi-running-raspbian/2337
How to connect
- Open ssh session
- Create a virtual desktop using vncserver
<syntaxhighlight lang="Bash"> pi@raspberrypi:~ $ vncserver -geometry 1920x1080 </syntaxhighlight>
- Connect to the virtual desktop
<syntaxhighlight lang="Bash"> Address 192.168.2.188:1 <- :1 is the desktop number </syntaxhighlight>\
- Kill the desktop when not needed
<syntaxhighlight lang="Bash"> pi@raspberrypi:~ $ vncserver -kill :1 </syntaxhighlight>
Hardware
Hardware | Picture | Link |
---|---|---|
Raspbery Pi | https://www.raspberrypi.org/downloads/raspbian/ | |
TFT | Configuration for the TFT | |
Camera 3EYE | Configuration for the 3EYE |